1. After adjusting the tension of the triangle tape during regular inspection, it still cannot meet the specified requirements, and the new triangle tape must be replaced. When replacing, all the belts on the same pulley should be replaced at the same time, otherwise due to the different old and new, the length is different, so that the load distribution on the V-belt is uneven, resulting in the vibration of the V-belt, the transmission is not stable, and the work efficiency of V-belt transmission is reduced.
2. In use, the operating temperature of the V-belt should not exceed 60°C, and do not apply belt grease casually. If you find that the surface of the V-belt is shining, it means that the V-belt has slipped, and the dirt on the surface of the belt should be removed first, and then an appropriate amount of belt wax should be applied. Clean the V-belt with lukewarm water, not cold and hot water.
3. For various types of V-belts, it is not suitable to coat rosin or sticky substances, and it is also necessary to prevent pollution of engine oil, butter, diesel and gasoline, otherwise it will corrode the V-belt and shorten the service life. The grooves of the V-belt must not be stained with oil, otherwise it will slip.
4. The V-belt should be kept when not in use, and should be kept in a place with a relatively low temperature, no direct sunlight and no oil and corrosive fumes to prevent it from deteriorating.